Udkik.dk

Review of Tanzer 27


Basic specs.

sail specifications
The Tanzer 27 is a sailboat designed by the American maritime architect C. Raymond Hunt. The Tanzer 27 is built by the Canadian yard Tanzer.

Here we would have liked to show you nice photos of the Tanzer 27.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Tanzer 27 or similar boat for sale

Hull
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

Rig
The boat equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

Engine

The boat is typically equipped with an inboard engine.

The transmission is a shaft drive. A shaft drive will in the long run require less maintenence than other types of drive e.g. a sail drive.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Tanzer 27 is 2.09, indicating that this boat would not be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 6.4 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Tanzer 27 is about 134 kg/cm, alternatively 755 lbs/inch.
Meaning: if you load 134 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 755 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Tanzer 27 is 19.7.

Low High 46% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 46% of all similar sailboat designs. This comfort value is just below average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Tanzer 27 is 2.79.

Slim Wide 79% 0 50 100
Compared with other similar sailboats it is more spacy than 79% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Tanzer 27 is 238 which categorizes this boat among 'light crusers & offshore racers'.

Heavy Light 50% 0 50 100
50% of all similar sailboat designs are categorized as heavier. This boat has a precise average ratio between displacement and length!


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Tanzer 27 with ISO 8666 reference sail is 15.8, with a 135% genua the SA/D is 19.0.

Low High 46% 0 50 100
The SA/D ratio indicates that it is faster than 46% of all similar sailboat designs in light wind.


Maintenance

Rig

Dimensions of sail for masthead rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 23.3 m(76.4 feet)8 mm(5/16 inch)
Jib/genoa halyard23.3 m(76.4 feet)8 mm(5/16 inch)
Spinnaker halyard23.3 m(76.4 feet)8 mm(5/16 inch)
Jib sheet 8.1 m(26.7 feet)10 mm(3/8 inch)
Genoa sheet8.1 m(26.7 feet)10 mm(3/8 inch)
Mainsheet 20.4 m(66.8 feet)10 mm(3/8 inch)
Spinnaker sheet17.9 m(58.8 feet)10 mm(3/8 inch)
Cunningham2.9 m(9.5 feet)8 mm(5/16 inch)
Kickingstrap5.8 m(19.0 feet)8 mm(5/16 inch)
Clew-outhaul5.8 m(19.0 feet)8 mm(5/16 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Tanzer 27 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References