Review of Reinke-Super 10

Reinke-Super 10
Reinke-Super 10 anno 1995.

Basic specs.

sail specifications
The Reinke-Super 10 is a sailboat designed by the German maritime architect Kurt Reinke.

Looking for a new boat? Find a Reinke-Super 10 or similar boat for sale

The boat is equipped with 5-7 berths.

Rig of Reinke-Super 10 anno 1995.

Keel of Reinke-Super 10 anno 1995.


The boat is typically equipped with an inboard diesel engine at 36.0 hp (26 kW).

The transmission is a shaft drive. A shaft drive will in the long run require less maintenence than other types of drive e.g. a sail drive.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Reinke-Super 10 is 1.79, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Reinke-Super 10 is about 246 kg/cm, alternatively 1382 lbs/inch.
Meaning: if you load 246 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1382 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Reinke-Super 10 is 3.06.

Slim Wide 66% 0 50 100
Compared with other similar sailboats it is more spacy than 66% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.

SA/D (Sail Area Displacement ratio)

SA/D (Sail Area Displacement ratio)
Indicates how fast the boat is in light wind:
- Cruising Boats have ratios 10-15
- Cruiser-Racers have ratios 16-20
- Racers have ratios above 20
- High-Performance Racers have ratios above 24
Sail-area/displacement ratio (SA/D ratio): 17.25



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

Guiding dimensions of running rig
Jib sheet 10.6 m(34.8 feet)14 mm(0.55 inch)
Genoa sheet10.6 m(34.8 feet)14 mm(0.55 inch)
Mainsheet 26.5 m(87.1 feet)14 mm(0.55 inch)
Spinnaker sheet23.4 m(76.7 feet)14 mm(0.55 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.


We are always looking for new photos. If you can contribute with photos for Reinke-Super 10 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.